Casting

Casting throat plates for horns

I've been working on making some midrange horns, and I want to make aluminum mounting plates for the compression drivers. One plate will be glued to the horn, and the other plate will bolt to the driver. Then that plate can be bolted to the plate on the horn to mount the driver to the horn. I didn't have enough aluminum plate sitting around to cut the throat plates out of, so I decided to cast them using scrap I'd collected. I think it's been about 4 years since I did any casting, so it took some work to get my setup running again.

In this first picture, you can see some of the throat plates I made - the discs on the ground. They're 6.5" in diameter and about 0.5" thick. I made five of these plus two throat adaptors for Parts Express horns (the other things on the ground next to the discs). Everything turned out pretty well except one of the throat adaptors - I ran out of aluminum while pouring so it had some shrinkages. It might still be usable.

Foam patterns for the throat plates:

The heat is cranked up. Scrap is being fed into the crucible. This is a really inefficient way to melt stuff - it goes much faster if I can actually fit it in the crucible.

A foam pattern buried in sand, ready to be cast. I'll pour metal on the exposed foam, and the metal will take the place of the foam almost instantly.

More melting:

Crucible full of molten aluminum:

The aftermath - the cast part is still in the sand on the left, with the overflow on top of the sand. An ingot of left over aluminum is cast in the baking pan. There's also a pile of dross in the baking pan. The empty crucible is in the middle still glowing slightly. The furnace on the right is still glowing a bit as well.

The finished parts (well, they still need machining...). The stripe across the disc is where I had masking tape covering some dings in the foam - it came out really well.